Custom steel fabrication · Melbourne’s East
Mon–Fri: 8 am to 5 pm
Custom steel fabrication · Melbourne’s East
Mon–Fri: 8 am to 5 pm
Custom steel swing gates, single or double, manual or automatic. Measured on site, fabricated in our Kilsyth workshop and installed by the same team.
A swing gate opens on hinges like a door, so it suits flat driveways with clear space to swing. Pick the layout that fits your entrance.
A single swing gate uses one leaf across the full entrance width.
A double (bi-parting) gate uses two leaves, so each leaf needs less swing clearance.
Not sure which suits your entrance? Tell us the width and the space around the gate and we will recommend the right setup. Ask us
Every gate is fabricated to the width, slope and clearance of your entrance, not a standard size adjusted after the fact.
Solid, slatted or open-design panels, chosen to suit your fence and home.
Built so a motor can be fitted on day one or added later.
Posts, hinges and hardware sized to the gate’s weight and daily use.
We visit your property and measure the entrance: width, slope, and the swing clearance in front of and behind the gate.
We design and fabricate the gate frame and panel in our Kilsyth workshop to match your fencing and site.
We install the gate and, if requested, fit or prepare it for automation.
Opens on hinges like a door.
Runs along the fence line.
Still deciding? Read sliding vs swing gates or see all our driveway gates.
Every swing gate we build is automation-ready, so you can fit a motor on day one or add it later without rebuilding the gate. Planning ahead means the frame and hinge posts are already built to suit hinge-mounted motors.
Gate automation · Best automatic swing gate opener in Melbourne
Single or double, opening width, panel design, finish and whether you automate. We measure on site and quote after, not from a stock price list.
A single swing gate uses one leaf across the full entrance width; a double (bi-parting) gate uses two leaves that meet in the middle, which suits wider entrances because each leaf needs less swing clearance.
It needs clear space to swing through an arc in front of and/or behind the gate, so it suits flat driveways with clearance. If you do not have the room, a sliding gate may suit better, and we will advise when we measure.
It depends on single or double, opening width, panel design, finish and whether you automate. We measure on site and give you a straightforward quote rather than a stock price. Our gate cost guide covers typical ranges.
Yes. We can build the gate automation-ready now and fit a motor later, or automate it from day one.
We can build swing gates to suit most standard and oversized driveways; the practical limit comes down to the available swing clearance, which we check on site.
We fabricate custom gates in steel and aluminium. Our aluminium vs steel guide explains the differences.
We install across Melbourne’s East, including Kilsyth, Croydon, Ringwood, Bayswater, Boronia, Montrose, Wantirna, Doncaster, Templestowe, Kew and Hawthorn.
We fabricate in our Kilsyth workshop and install across these suburbs and the surrounding areas.
Tell us what you need and we will come back with next steps and a time to measure.
